ADRF5024-EVALZ

ADRF5024-EVALZ is an ADRF5024 reflective, single-pole double-throw (SPDT) switch evaluation board. It is a fully populated, connectorized evaluation board using 4-layer, 62 mil thick, RO4003 PCB material. For normal operation, two supply voltages +3.3V and -3.3V should be applied to the VDD and VSS test points respectively, while their ground voltages are connected to the GND test point. Control input voltage, 0V or +3.3V, should be applied to the CTRL test point to select the switch state between RFC-RF1 and RFC-RF2. The RF input signal can be applied at the edge-launch, 2.4mm RF connector labeled RFC and the RF output signals can be measured at the edge-launch, 2.4mm connectors labeled RF1 and RF2.

Notes

ADI products are only authorized (and sold) for use by the customer and are not to be resold or otherwise passed on to any third party